OBDII инструмент за диагностичен ремонт за DIY BMW Owner Fit BMW E36/E46/E34/E38/Z3/X5/X3
OBDII инструмент за диагностичен ремонт за DIY BMW Owner Fit BMW E36/E46/E34/E38/Z3/X5/X3
OBDII инструмент за диагностичен ремонт за DIY BMW Owner Fit BMW E36/E46/E34/E38/Z3/X5/X3
OBDII инструмент за диагностичен ремонт за DIY BMW Owner Fit BMW E36/E46/E34/E38/Z3/X5/X3
Previous
Next

OBDII инструмент за диагностичен ремонт за DIY BMW Owner Fit BMW E36/E46/E34/E38/Z3/X5/X3

Референция: bmw b800 scanner
26,00 €
С вкл. данък

This BMW srs reset tool only works on the vehicles between the years of 1994 - 2003 as below:

E36 - 316 THROUGH TO M3 (SALOON, COUPE, COMPACT, CONVERTIBLE & TOURING)

E46 - 316 THROUGH TO M3 (SALOON, COUPE, COMPACT, CONVERTIBLE & TOURING)

E34 - ALL VARIANTS

E38 - ALL VARIANTS

E39 - ALL VARIANTS

Z3 - ALL VARIANTS

Z4 - ALL VARIANTS

X5 - ALL VARIANTS

Note: B800 OBDII scanner can not do 2001 BMW 330i.

B800 airbag reset tool in your car is an important safety device

  • Its module is designed to ensure that it is functioning properly.
  • Whenever an explosion occurs in a B800 airbag, light is turned on and both the airbag and the controller ought to be replaced.
  • However, with the B800 airbag tool, the software can still be automatically restored under the conditions that there’s no damage to the controller’s hardware and you’ll only be required to replace the airbag only; the controller can still be used again.
  • You can use the tool to repair and reset the airbag computer in your office in one minute without necessarily removing the sensor from the car.

Also Can Be Use CAN Bus

  • There are cases when their “crash erase” works only on the table. Should you be defeated to erase the crash data by OBD2 connector, try to disconnect the instrument cluster blue connector and erase by OBD2 again. Sometimes the red diode may appear, indicating a crash data erase error, if this happens, simply remove the airbag sensor from the car and connect it directly to the table and the erasing will be OK.
  • In some rare occasions the B800 airbag reset system may fail to clear the warning light or reset the service mileage at the very first instant. This is usually caused by the failure of the reset tool to get feedback from the ECU over whether the operation was successful or not. In such a situation the tool will simply send instructions to the ECU to reset, but once the operation is finished it will display “RESET OK!” without acknowledgement from the ECU.

bmw b800 scanner