MW126CB50

High Speed Battries Charger 6v-24v 20A (SUITABLE FOR BATTERY BELOW 40 AH) 230V

14,00 € tax excl.

More info

Efficient High Speed Battries Charger Copper Transformer 6v - 12v 20A car battery charger (Suitable for Batteries Below 40AH) Input Voltage 210V-230V Product details of Efficient High Speed Battries Charger Copper Transformer 6v - 12v 20A car battery charger (Suitable for Batteries Below 40AH) Input Voltage 210V-230V Product Application(Suitable for Batteries Below 40AH) Input Voltage 210V-230VInstructions for use of chargerThe machine output battery clamp into the battery postive, negative, note that the red clamp is positive, battery positive, green or black clamp is negatve, battery negative, not clip. 2 Set the charge current regulator switch to the minimum (weak) positionand the battery selector switch is connected to desire voltage position. Tum on the power switch (NO) position and the indicator light is on. 3. Adjust the charging current according to the requirement and the battery capacity. If it is not used urgenty, it should be charged according to the 1/10 standard of the capacitance. If it is needed urgenty it can be charged twice as much as the standard charging current This can reduce the charging time by half.In the absence of any instruments,a large number of bubble appears in th battery.it means that electricity is basically full (for exception the bad baterry)Turn off the machine, press the power switch to be off POSITION,ADJUST THE CURRENT REGULATOR SWITCH TO THE MINIMUM POSITION,DISCONNECT THE POWER SUPPLY,REMOVE THE BATTERY CLIP,WIPE THE CLIP ON THE SULFURIC ACIS AND OTHER STOLEN GOOD CLEAN, WAITING FOR THE MACHINE TO COOL DOWNFOR THE NEXT USE.THE MACHINE IS IN THE NORMAL INPUT VOLTAGE RANGE, USING THE CURRENT REGULATING OF 3-5 GEAR, CHARGING ABOUT 8 hours battery full, urgent need to adjust to

30 other products in the same category: