ΠΛΑΚΕΤΑ ΜΕ ΜΙΚΡΟΕΠΕΞΕΡΓΑΣΤΗ PIC32MX795F512H - ARDUINO LIKE

20,00 € tax excl.

More info
Data sheet

More info

The special T-form of this board allow it to snap-on BREADBOARD-1 and to supply directly the VCC and GND to the Breadboard bus. It is perfect for fast breadboarding with Jumper Wires

FEATURES

PIC32MX795F512H 80 Mhz microcontroller 512KB Flash 128KB RAM , 3x SPI, 4x I2C, USB OTG, 1MSPS ADC, PMP 80Mhz digital capture, 5 TIMERS/CCP, 53 GPIOs
USB-OTG supporting both host and device function allowing the implementation of Google Android ADK
UEXT connector which allows the connection of many existing modules with RF, ZIGBEE, GSM, GPS functionality
Two LEDs
One BUTTON
Reset button
A Mini USB connector is used which is common and used in most cell phones, so you do not have to buy additional cables
All PIC ports are available on 0.1" connectors
ICSP connector for programming with PIC-KIT3
Dimensions 87x54 mm (3.4x2.12")

DOCUMENTS

HARDWARE

PIC32-T795 Rev_A schematic in PDF format
PIC32-T795 Rev_B schematic in PDF format
PIC32-T795 schematic and board file Rev_B in Eagle format released under Creative Commons Attribution-Share Alike 3.0 United States License

SOFTWARE

PINGUINO IDE installtion:
- PINGUINO IDE supports PIC32MX795F512 binary file might be found in the PINGUINO folders
- PINGUINO files - bootloader, pin definitions, blinking LEDs example
DUINOMITE IDE files:
- PINGUINO IDE original bootloader used during production
- GitHub software
General purpose examples:
- Customer project with MOD-WIFI note that this requires a PIC32-compatible programmer
MPIDE related:
- PIC32-T795 complete library example for MPIDE
- MPIDE wiki article

WARNING

Do not use the "programmer-to-go" button when there is no image on the OLIMEX PIC-KIT3 or MICROCHIP PIC-KIT3 because that might put your microcontroller in an irrecoverable state. We have tested the mentioned scenario and we can confirm it destroys PIC32 chips (using both our and the original Microchip PICKIT3). We don't take responsibility if you break your chip that way. For more info check the following: www.microchip.com/forums/m635420.aspx.